Drywall Installer

Clean and prepare surfacess

Mix plaster ingredients in trough to desired consistency

Apply, level and smooth coats of plaster using trowels, floats, brushes and spraying equipment

Finish corners and angles and create decorative designs in finish coat, if .

Cure freshly plastered surfaces. 

Spray acoustic materials or texture finish over walls and ceilings. 

Measure, cut and fit drywall sheets for installation on walls and ceilings.

Position and secure sheets to metal or wooden studs or joists.

Cut and install metal corner beads to protect exterior corners. 

Fill joints, nail indentations, holes and cracks with joint compound using trowel and broad knife. 

Tape over joints using taping machine and embed tape in compound. 

Smooth out excess compound and allow coat to dry. 

Apply successive coats of compound and sand seams and joints. 

Fabricate and install suspended metal ceiling grids and place in panels to form acoustical and coffered ceilings. 

Prepare wall and ceiling layouts. 

Install metal stud framing and furring for interior drywall or plaster walls and ceilings, using hand and power tools. 

Attach metal or gypsum lath to studs or furring using nails, screws, clips or wire ties. 

Cut openings in lath for heating and ventilation piping, ducts and electrical outlets. 

Install corner beads and wire mesh around beams to which plaster is to be applied. 

Install acoustic tile, hangers for suspended ceilings and metal studs for composition wallboard or lath.