Service Technician

Responsible for the strip down, assessment, measurement and reporting on pumps/rotating equipment sent in for repair

Liaise with Manager, Service/Supervisor, Service in order to assess any technical requirements that may affect prospective work or work in progress

Service and assembly of pump sets and associated equipment including repair of fittings, fixtures and structures

Perform spray painting using single pack enamel paint

Maintain cleanliness and safety of work area and workshop equipment and maintain tools and equipment in operating condition and advise supervisor of deficiencies

Remove impellers for turndown and refit the same and complete impeller turndowns

Complete rotating equipment alignment to nominated tolerances using dial indicators or laser equipment

Complete the assembly of close-coupled pumps, gearboxes and motors

Complete the set out and drilling of equipment skids

Manufacture simple sheet metal coupling guards

Follow written instructions and complete all nominated checkpoints before handover of paperwork

Provide timely advice to Supervisor for service of stock deficiencies to allow replacement for workshop and site work

Demonstrate an ability to fault find and self-manage so as to avoid unnecessary breakage or lost time through incorrect fitting techniques

Complete hydrostatic tests to nominated standards and as per specific directions

Any other tasks as advised by their Manager or Supervisor that are within their skills and competence.