Process Engineer

Process Engineer /Process Design Engineer

Process design and engineering experience of 8 to 12+ years in Oil & Gas  projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.

Required Experience:

The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.

• Design Basis


• Licensor Technology Evaluation


• PFD and P&ID Preparation and or review for Urea Plant


• HMB


• Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,


• PSV Relief load estimation, PSV sizig


• Flare sizing, KOD sizing 


• Pump sizing


• Compressor Calculations, Anti surge design, settle out calculations etc


• Steam generation and sizing calculations


• Design of  Separators, columns, Heat Exchangers, tanks 


• Hydraulic calculations, PSV sizing, Control valve sizing calculations


• Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages 


• 3D Model Review


• vendor offer reviews


•  Experience across conceptual design, FEED, and detailed engineering phases.


• Operation experience is not preferred.

Software/Technical Skills & Tools

- Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.

- Strong understanding of process design, sizing, and optimization techniques.

- Ability to critically review calculations and propose practical engineering solutions.

- Strong technical documentation and report-writing skills.

- Fluent in spoken and written English.

Education:

• B tech Chemical Engineering / MTech Chemical Engineering


• 75% Marks in engineering are mandatory

Job Profile

Key Responsibilities

- Perform process design review and verification across conceptual, FEED, and detailed engineering stages.

- Prepare and review process design basis, philosophies, and engineering calculations.

- Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).

- Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.

- Perform and review PSV relief load estimation and PSV sizing calculations.

- Review flare system calculations, knockout drum sizing, and associated hydraulics.

- Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.

- Review design of separators, columns, heat exchangers, tanks, and other process equipment.

- Perform hydraulic calculations and control valve sizing reviews.

- Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.

- Participate in 3D model reviews and vendor technical document reviews.

- Prepare and review technical reports, calculation notes, and design review comments.

- Ensure compliance with applicable international codes, standards, and project procedures.

- Site Visit : The candidate may be required to occasionally visit project sites to conduct audits or verification activities.

Location:  Abu Dhabi, UAE