Electronics Test Technician - 1st 2nd or 4th shift

The selected candidate must be able to apply electronic principles to test and troubleshoot complex circuits and devices for circuit cards, sub-assemblies, and large cabinet systems. The Electronics Test Technician should also be proficient at using a broad range of measuring and monitoring equipment (e.g., oscilloscopes, function/waveform generators, counters, power supplies, multi-meters, current sensors, voltage/current probes, etc.) to both perform the tests as specified and to troubleshoot down to the component level. The Test Technician will perform acceptance test procedures that verify equipment function. This includes, but is not limited to, the following: Selection, setup, calibration, and operation of simple to complex equipment and facilities over a broad spectrum of technologies in the process of testing a unit. Verification and validation of product and paperwork configuration, test processes, and test equipment setup, configuration, and calibration. Measuring, collecting, and recording electrical performance data as required by the test specifications, as well as performing analysis and evaluation of the data to the test specification requirements. Preparing accurate and complete test reports of all recorded data for government submittal. Troubleshooting of systems, devices, test tools, processes, and/or test setups to locate and repair defective areas. Performance of Insulation Resistance and Dielectric Strength Tests to determine the effectiveness of the component or product's insulation. Performance of Manual and Automated Full Load (Burn-in) tests. Performance of Manual and Automated Functional, Operational, and System Tests. Performance of other miscellaneous tests (e.g., Thermal, Liquid Cooling, Fiber Optic, etc.). Assisting engineers in performance of design verification tests including the setup and operation of test equipment. Performing initial procedural tests on new and/or changed equipment to verify that the tests can be performed as specified. Performing maintenance and integration of peripherals. Performing Test Tool Calibration and Certification/Verification. Building/Constructing test tools and stations using schematics, diagrams, and wiring tabulations. Ability to work 1st, 2nd or 4th shift High School diploma and an additional 6 years of relevant education and/or experience Associate of Science degree or higher (or Technical degree) in electronic technology or electronics focused major OR graduate of a two-year, full time electronic technology school or six months of military electronics school A minimum of 2 years of electronics experience troubleshooting complex circuits and devices Experience using measuring and monitoring equipment such as oscilloscopes, function/waveform generators, power supplies, multi-meters, current sensors, and probes Experience reading and interpreting wiring diagrams and schematics Ability to perform moderate strenuous physical and repetitious work to include: bending, stooping, kneeling, carrying tools, lifting up to 35 pounds, working in confined spaces, and standing for long periods of time Ability to work around high voltage and current Ability to perform assignments in locations which could cause various phobias due to height or enclosed spaces Ability to perform assignments in varying external and internal environmental conditions Ability to accept up to 10% travel to various physical locations domestic and international Must pass pre-employment skills assessment Must be able to obtain and maintain a DoD Secret level clearance US Citizenship is required. Experience using SAP Manufacturing Execution System (MES) software to document testing performed, enter test results, & create Quality Notifications for any discrepancies found Experience using National Instruments hardware and LabVIEW software to perform product testing Experience with Microsoft Office applications (e.g., Word, Excel, PowerPoint, Outlook, & TEAMS) Experience using Mission Product Lifecycle Management (MPLM) Engineering Configuration Management Software (Supersedes CADSTAR) Current, active Secret Clearance Military experience working with U.S. Navy electronic equipment/systems Experience with continuous improvement and process improvement principles